Handheld TerminalUser’s GuideSeriesBe sure to read “Safety Precautions” inside this guide before trying to use your Handheld Terminal. E
E-8Operating PrecautionsYour Handheld Terminal and its options are precision. Improper operation or rough handling can cause problems with data storag
E-9Lithium-ion Battery PackEach lithium-ion battery pack has its life. The life span heavily depends on how the battery pack is charged or stored whic
E-10Important This guide does not include any information about programming and download procedures. See the applicable separate documentation for inf
E-11Regulatory InformationThe USA and CanadaGUIDELINES LAID DOWN BY FCC RULES FOR USE OF THIS UNIT IN THE U.S.A. (not applicable to other areas).NOTI
E-12L’utilisation de ce dispositif est autorisée seulement aux conditions suivantes :(1) il ne doit pas produire de brouillage et(2) l’utilisateur du
E-13Checking in the BoxPlease check the contents of the box before using the Handheld Terminal for the fi rst time. Open the box and make sure that al
E-14Handheld Terminal System Confi gurationOptions HA-D20BAT-ADual Battery Charger Battery Pack HA-D32DCHGAC Adaptor forDual Battery Charger AD-S42120B
E-15Options USB and Charging UnitHA-J65USScreen Protect SheetHA-J90PS5Cables HA-J80USBM HA-J81USBH
E-16General GuideIT-300Left13141236458791112106Front Right171616TopBottom191516172324222021Back12 18
E-171 Indicator 1 Orange: ChargingGreen: Charging completeRed Flashing: Battery pack error or the surrounding temperature is out of the charging tempe
Information in this document is subject to change without advance notice. CASIO Computer Co., Ltd. makes no representations or warranties with respect
E-1820 microSD Card Slot CoverSlot a microSD card into here.21 Lock Switches Used to lock the covers and to release.22 Battery Pack Cover Used to cove
E-19USB and Charging Unit213Top Bottom4Left4Right1 AC Adaptor Jack Connect the AC adaptor here.2 USB Port Connect the cable (HA-J80USBM) here.3Power S
E-20Loading and Removing the Battery PackYour Handheld Terminal uses two types of battery: a battery pack and a memory backup battery.The battery pack
E-21Loading1. Turn the terminal over, turn the lock switch for the battery pack cover to the “FREE” position (), and then remove the battery pack cove
E-22Removing1. Make sure that the Handheld Terminal is turned off. If the power is on, press the power key to turn it off.2. Turn the terminal over,
E-23Handling the USB and Charging Unit (HA-J65US)Mount the USB and Charging Unit on the terminal when using the unit to charge the battery pack in the
E-24Removing the USB and Charging Unit1. Unlock the stoppers on the left and right sides of the USB and Charging Unit by pressing them inwards, as sho
E-25Connecting to a ComputerYou can use the USB and Charging Unit together with the cable (HA-J80USBM) to connect the IT-300 to a computer and exchang
E-26Charging the Battery PackThe battery pack installed in the IT-300 can be charged using the optional AC adaptor (AD-S15050B). An indicator on the I
E-27Dual Battery Charger (optional)Use the optional AC Adaptor for Dual Battery Charger (AD-S42120B).AC Adaptor (AD-S42120B)You can connect up to thre
E-1ContentsSafety Precautions ...E-3Operating Precautions ...
E-28Attaching the Neck StrapThe neck strap can be used to prevent the Handheld Terminal from fall. Since there are three strap holes where the neck st
E-29Using the Touch PanelUse the touch panel by touching it lightly with your fi nger. Do not use objects other than your fi nger.You can use the touch
E-30Setting the Display BrightnessAdjusting Display BrightnessYou can use the following procedures to adjust display brightness to make it easier tore
E-31Using the Laser Scanner1. After turning on the power, position the laser scanner close to a bar code and then press the trigger key.2. The laser e
E-32Bar Code Scanning PositionPosition the laser scanner close to the bar code when scanning small bar codes.Position the laser scanner at a distance
E-33Adjusting the Laser Light Emission WidthThe emission width of the laser light emitted by the Handheld Terminal (model dependant) can be adjusted.
E-344. Tap the [Calibration] button. The display appears as shown at right.5. Press the trigger key to emit laser light, and align the light with the
E-35Handling microSD CardsThe Handheld Terminal supports microSD card.Install (or remove) a microSD card according to the procedure described below.In
E-36Removing1. Turn the terminal over, turn the lock switch for the microSD card slot cover to the “FREE” position, and then remove the microSD card s
E-37Performing Bluetooth® CommunicationBluetooth® interface can also be used to transfer data between two Handheld Terminals. With Bluetooth® the two
E-2Performing Bluetooth® Communication ...E-37Resetting the Handheld Terminal ...
E-38Resetting the Handheld TerminalResetting the terminal is the same as resetting a PC. Performing a reset causes all unsaved RAM data to be lost tha
E-391. While holding down the Fn key and CLR key, push down the reset switch for about 3 seconds with the tip of a pointed implement such as a mechani
E-40Warning Label Warning! Never look directly into the laser light.These products scan using laser light. Never look directly into the laser light o
E-41Using the Dual Battery Charger (HA-D32DCHG)The optionally available dual battery charger (HA-D32DCHG) can be used tosimultaneously charge two batt
E-421 Charge Indicator LampThis lamp indicates the charge status of the battery pack(s).Off: Not chargingRed: ChargingRed Flashing: Battery pack probl
E-43Charging a Battery PackUse the optionally available AC adaptor (AD-S42120B) for the power supply of the Dual Battery Charger.1. Plug the cord from
E-44Connecting Multiple Dual Battery ChargersYou can connect up to three Dual Battery Chargers. Doing so makes it possible to supply power to all the
E-45Specifi cations1. Model: HA-D32DCHG2. Charging:Charging Method: Constant voltage (with current limiter) (when one Handheld Terminal has been mou
E-46Using Rechargeable Battery PackHA-D20BAT-AImportant!Store a battery pack in its special soft case whenever you are not using it.If the battery pac
E-47Specifi cations IT-300Model: IT-300-15ECPU: Marvell® PXA320 624MHzMemory: 256MB RAM, 256MB Flash ROM (user defi ned: 120MB)OS: Microsoft® W
E-3Safety PrecautionsCongratulations upon your selection of this CASIO product. Be sure to read the following Safety Precautions before trying to use
E-48Battery Life: Battery pack: Approximately 11 hours* Approximately 10 hours*** under the conditions that CPU speed is set to the
E-49USB and Charging UnitCharging: Charging Method: Constant current/voltage Charge Period: Approximately 4 hours (AD-S15050B)Power Supply: Power
CASIO COMPUTER CO., LTD.6-2, Hon-machi 1-chomeShibuya-ku, Tokyo 151-8543, Japan
E-4 WarningDust and MoistureThough the Handheld Terminal is dust and water splash resistant, its options including the battery pack are not. Keep loos
E-5 CautionForeign ObjectsTake care to ensure that metals or combustible objects are not inserted into the openings of the Handheld Terminal or its o
E-6Optional Lithium-ion Battery Pack DangerNever use the Handheld Terminal and its option including the battery pack and battery next to open fl ame, n
E-7Power Supply / AC Adaptor WarningDo not use the Handheld Terminal at a voltage other than the specifi ed voltage. Also, do not connect the Handheld
Commentaires sur ces manuels