Casio DT-X30 R-50C Spécifications télécharger pdf (Page 106)

106

2.8.3 Roaming

This feature automatically switches one Access-Point to another in where two or more

Access-Points with the identical SSID code exist are installed.

1. Searches for Access-Points that can communicate with the terminal, and lists up radio wave

status of each Access-Point.

2. Compares radio wave status of the currently connected Access-Point with those for the listed

Access-Points.

3. If the comparison proves that one of the listed Access-Points has a better radio wave status than

the one currently being connected with the terminal, the terminal will make a request of

roaming to that Access-Point.

4. If roaming permission comes from the Access-Point to the terminal, the roaming will complete.

Note that if the roaming fails, the connection establishment will be disconnected and then

connected again.

Notes:

• In some cases, the Access-Point may request the terminal for forcible roaming or reconnection

with another Access-Point.

• If connection establishment of the Access-Point being connected with the terminal is

terminated due to some reasons such as turning off the power on it, the terminal may be forced

to make a connection with another Access-Point.

• If it takes time for Access-Point to correspond for roaming request made by the terminal, the

reconnection process may be initiated.

• If DeAuthentication or DisAssociation message issued by the Access-Point that is being

connected with the terminal is received by the terminal after roaming completed, the

connection establishment between the Access-Point and the terminal may be interrupted

temporarily and then connected again.

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 332 333

Pas de commentaire

Casio DT-X30 R-50C Spécifications Page 106