Casio ClassPad II fx-CP400+E Manuel d'utilisateur télécharger pdf (Page 2)

Using the E-CON3 Application

The E-CON3 application makes it possible for you to control a Data Logger from a connected

ClassPad. It allows you to perform the following operations from the ClassPad unit.

• Configuring Data Logger sampling parameters

• Starting and ending a Data Logger sampling operation

• Saving sample data

• Analysis and graphing of sample data

Important!

• All explanations in this section assume that you are fully familiar with all

ClassPad and Data Logger (CMA CLAB* or CASIO EA-200) precautions,

terminology, and operational procedures.

• The E-CON3 application is designed to get the most out of the

measurement functions of the CASIO EA-200 Data Logger. Though it can

run on a CMA CLAB Data Logger, CLAB does not have a SONIC port,

microphone, or speaker as is equipped on the EA-200. While a ClassPad

is connected to a CLAB Data Logger, attempting to configure E-CON3

application settings and perform measurement using parameters that are

not supported by CLAB will cause an error.

* For information about CMA and the CLAB Data Logger, visit

http://cma-science.nl/.

1 2 3 4 5 6 7 ... 82 83

Pas de commentaire

Casio ClassPad II fx-CP400+E Manuel d'utilisateur Page 2