Casio AP-80R Manuel d'utilisateur télécharger pdf (Page 40)

E-38

Rotate height adjustment screw

until it supports

crosspiece D, preventing the crosspiece from bending

when you press the pedals (Figure 5).

IMPORTANT!

• Be sure to rotate adjustment screw

and perform the adjustment

procedure described above before depressing the pedals. Failure

to do so can result in damage to crosspiece D.

Attach back panel C to the

brackets and crosspiece

D. Note that the back panel C should be installed so it

is in front of the

brackets (Figure 4). Use the four I

screws, six F screws to secure the back panel in place

(Figures 3 and 4). Note that you must also install the G

clip at this time as shown in the illustration.

• First, install the topmost I screws on the left and right

sides of the back panel C. Note that you should slip the

G clip onto the F screw at point

before you screw in

the F screw.

• The back panel C should rest on the feet of side uprights

A and B as indicated by

in the illustration. Press the

back panel C against crosspiece D while installing the I

screws.

Figure 4

(Back)

Figure 5

Assembly Instructions

429A-E-040A

AP80R_e_29-41.p65 04.8.26, 3:44 PM38

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 52 53

Pas de commentaire

Casio AP-80R Manuel d'utilisateur Page 40