Casio YA-S10 Setup Guide Manuel d'utilisateur télécharger pdf (Page 32)

E-31

Normal Operation after Getting Ready

After you finish the procedure under “Getting Ready” (page E-11), you will be able to use the projector

system (Control Box plus one or two projectors) as if it were a single projector. Perform the procedures in

this section using the Control Box remote controller.

To turn on Projector System power

Press the [ALL] key. This will turn the Control Box, Projector A, and Projector B power.

If you are using a configuration that has multiple Control Boxes, press the numbered power key ([1]

through [4]*) assigned to the Control Box you want to turn on.

* For more information, see “To configure initial Control Box settings” (page E-14) and “Control Box

Power On/Off” (page E-14).

To change the input source

When both HDMI input and RGB (or component) input sources are connected to the Control Box, you

can use the remote controller [INPUT] key to toggle between them. Follow the instructions on the dialog

box that appears when you press the key.

To turn off Projector System power

Press twice the [ALL] key or the numbered power key ([1] through [4]) assigned to the Control Box you

want to turn off.

NOTE

z For full details about using your Projector System, see the “YA-S10 User’s Guide”.

1 2 ... 27 28 29 30 31 32 33 34 35 36

Pas de commentaire

Casio YA-S10 Setup Guide Manuel d'utilisateur Page 32