Casio PJ Camera Software 1.2 Guide de l'utilisateur télécharger pdf (Page 43)

Using the PJ System Like an OHP Projector (Document Camera Mode)

3. While watching the monitor screen image, configure the settings you

want.

z To change the zoom setting, click the [Wide] or [Tele] button. You can select a zoom

factor in the range of 1X to 3X. The initial default zoom setting is 1X.

z To adjust focus, display the operation bar and then select [Camera] and then [Refocus],

or press the computer keyboard’s [F2] function key. If the currently selected zoom factor

is larger than 1.8X when you press the [F2] function key, it will change to 1.8X.

You can also focus manually using the four buttons to the right of the [Refocus] button.

4. After all the settings are the way you want, click [OK] to apply them

and close the dialog box.

z You can display the dialog box for adjusting the document camera while a document

camera image or rough (monitor) image is being projected.

z PJ Camera settings you configure are retained until you change them again, or until you

quit PJ Camera Software. Quitting PJ Camera Software causes settings to return to their

initial defaults.

z Pressing the [Refocus] button during manual focus and while the current zoom setting is

greater than 1.8X will cause the zoom setting to change automatically to 1.8X.

To do this: Click this button:

Make a relatively large change in the focus setting [<<] / [>>]

Make a fine adjustment of the focus setting [<] / [>]

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 145 146

Pas de commentaire

Casio PJ Camera Software 1.2 Guide de l'utilisateur Page 43