Casio KL-100 Manuel d'utilisateur télécharger pdf (Page 8)

E-7

INT?

Turning Power On and Off

Press ON to turn power on, and OFF to turn power off.

Important!

• If you are using the Label Printer for the first time, you should reset it first.

Resetting the Memory

You should reset the memory of the Label Printer before using it for the first

time, after you have not used it for a long time, or if nothing happens when you

turn power on, even after you change the batteries.

Important!

• Resetting Label Printer memory clears its memory of all input data.

To reset the memory

1. Make sure that Label Printer power is off.

2. While holding down the PRINT and ESC keys,

press ON to turn power on.

3. Keeping PRINT and ESC held down, release

the ON key only.

4. Press SET to initialize the Label Printer or ESC to abort the reset operation

without initializing anything.

• See “Initializing the Label Printer” on page 18 for information on the initial

default settings of the Label Printer following the reset operation.

Auto Power Off Function

If you do not perform any key operation for about six minutes, the Label Printer

automatically turns power off. To restore power, press ON.

Tape Cartridges

Use the procedures described below to load a tape cartridge into the Label

Printer. After you load the tape cartridge, be sure to use the procedure de-

scribed under “Tape Width Specification” on page 8 to tell the Label Printer

what is the width of the tape you are using.

AC Adaptor

Note the following important precautions when using an AC adaptor to power

your Label Printer.

• Use only a genuine CASIO AD-A95100 AC adaptor with the same voltage

rating as the household current in your area. Using a wrong adaptor can

damage your Label Printer.

• Be sure to turn the Label Printer off before you connect the adaptor. Do not

turn power on until the adaptor is connected to the Label Printer and plugged

into and AC outlet.

• Be sure to unplug the AC adaptor from the AC outlet whenever you are not

using the Label Printer.

AC Adaptor Cap

Remove the ADAPTOR CAP before connecting

the AC adaptor.

Insert the adaptor cap into the ADAPTOR CAP

holder located inside the back cover to avoid

losing the cap.

To connect the AC adaptor

Connect the adaptor to the Label Printer as shown

in the illustration. Plug the other end into a stand-

ard household AC outlet.

ADAPTOR CAP

Inside

back cover

ADAPTOR

CAP holder

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 23 24

Commentaires sur ces manuels

Pas de commentaire

Casio KL-100 Manuel d'utilisateur Page 8

Commentaires sur ces manuels

Produits connexes et manuels pour Imprimeurs Casio KL-100