Casio fx-CG500 Manuel d'utilisateur télécharger pdf (Page 17)

Configuring Parameters for Sampling with Multiple Sensors

Use the [Multiple] tab to configure parameters for simultaneous sampling with multiple

sensors. The [Multiple] tab lets you select up to three channels for sampling, from among the

Data Logger’s CH1, CH2, CH3, and SONIC* channels.

* EA-200 only

To configure parameters for sampling with multiple sensors

(1) Start up the E-CON3 application.

• This displays the [Single] tab of the Sensor Setup window.

• If the E-CON3 application is already running and another window (besides the Sensor

Setup window) is displayed, tap

to change to the Sensor Setup window.

(2) Tap the [Multiple] tab.

• This displays the [Multiple] tab, which appears as shown

to the right.

(3) Tap inside the box of one of the sensors you want to

select ([CH1], [CH2], [CH3], [SONIC]).

• This causes a Select Sensor dialog box like the one

shown to the right to appear. The dialog box shown

here is for CH1, CH2, and CH3.

2-7

Basic Steps for Configuring Sampling Parameters

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 82 83

Pas de commentaire

Casio fx-CG500 Manuel d'utilisateur Page 17