Casio fx-CG500 Manuel d'utilisateur télécharger pdf (Page 53)

8-1

Graphing Data

8 Graphing Data

This chapter explains how to configure graph parameters on the E-CON Graph Editor

window, and how to draw a graph on the E-CON Graph window.

E-CON Graph Editor Window

To graph sample data, you first need to tap the

button and display the E-CON Graph

Editor window, where you can select the sample data you want to graph.

The E-CON Graph Editor window has three tabs: [Current], [Normal], and [Compare].

Each of the tabs is described in detail below.

Tip

• Note that each time you perform a sampling operation, all of the current data on the [Current] tab

(or the sampled data you recalled for each graph) is cleared and replaced with the newly sampled

data. A sampling operation does not have any affect on the [Normal] tab and [Compare] tab.

[Current] Tab

The [Current] tab shows the current data (page 5-5). Use this tab when you want to draw a

graph of the current data following a sampling operation.

The [Current] tab can be either of the two styles shown below.

Gph1, Gph2, Gph3 Style

This is the same style as the [Normal] tab (see page 8-3).

This is the style that is displayed following sampling with most sensors. This style also

appears if you have not performed a sampling operation to produce current data, and

following the Clear All operation (page 8-10).

Except for the fact that the [Current] tab Gph1, Gph2, and Gph3 graph data is replaced by

the latest sampling operation, the operations for this tab style are identical to those for the

[Normal] tab.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 82 83

Pas de commentaire

Casio fx-CG500 Manuel d'utilisateur Page 53