Casio GRAPH90+ E Manuel d'utilisateur télécharger pdf (Page 617)

100

101

ε-7

Sampling Screen

6. Press 6(DRAW) to draw the graph.

Drawing the graph causes a vertical cursor to appear on the display, as shown on the

screenshot below. Use this graph to specify the range of the sound output from the

speaker.

7. Use the d and e keys to move the vertical cursor of the output range start point and

then press w to register the start point.

8. Use the d and e keys to move the vertical cursor of the output range end point and

then press w to register the end point.

Setting both the start point and end point will cause the Output Frequency dialog box

shown below to appear.

9. Specify the output frequency percent (%) value.

To output the original sound unchanged, specify 100 (%). To output a sound one octave

higher than the original sound, input 200 (%). To output a sound one octave lower than

the original sound, input 50 (%).

10. Input a percent (%) value and then press w.

This outputs the sound of the waveform within the selected range.

If the specified result cannot be output as a sound, the message “Range Error” will

appear. If this happens, press J to display the screen shown below and change the

settings.

11. To stop sound output on the EA-200, press the [START/STOP] key.

12. Press w.

This displays a screen like the one shown below.

•

1 2 ... 612 613 614 615 616 617 618 619 620 621 622 ... 662 663

Commentaires sur ces manuels

Pas de commentaire

Casio GRAPH90+ E Manuel d'utilisateur Page 617

Commentaires sur ces manuels

Produits connexes et manuels pour Pompes à eau Casio GRAPH90+ E